Air Cooled Chiller Model : HEAVY-Semi Hermetic R134

Compact dimensions with high body strength and simple piping

Body with 1.5 mm thick galvanized sheet

Easy to remove coil and fan

Sheet Forming for the strength of the body

Drain Pan foe removing watert of Condenser

Separation of evaporator and piping from the condenser section

The device is washed and painted with electrostatic powder paint.

It is made of standard studs with the standard size

Using Bitzer semi hermetic compressors with different circuits

Condenser design up to 40 C ambient Tempreture

The possibility of adding fans by steps

The possibility of producing condenser coil with aluminum coating (Blue Fin)

Fin density up to 12 fins/inch for minimal pressure drop

Zillabag axial condenser fans with low speed

Shell & tube evaporator for long life and prevent freezing in the cold season

The thickness of the evaporator shell is 6 mm and the use of a copper tube with a thickness of 0.8 mm

Evaporator nut connections and no welding in the pipe shell

Antifreeze and thermostat to adjust the water temperature

strainer to filter water and prevent sand from entering the evaporator

Using a flow switch to control the flow of water in the circuit

Electrical panel with thermal, miniature and non-metal switches for electrical protection of the device

High IP for Electrical panel

The possibility of adding a controller to Electrical panel

Liquid line includes solenoid valve, site glass, filter drier

Use of 4-tube accumulator for high efficiency for suction line and discharge

High & Low safety valve to protect the compressor at low and high pressures

Using a receiver to saving Refrifrant for repairs

high pressure sensor (KP) to control the addition of a fan to the circuit

Elastomeric insulation for all suction line piping and prevent heat exchange

Controller : DANFOSS or CAREL or mechanically and PLC

Circulation pump for mini chiller water circuit

The possibility of adding an expansion tank inside the device